Walkera 4#3B Throttle Curve, D/R and Expo with the 2801Pro
Walkera 4#3B and the 2801Pro - Micro Heli Dreamteam
With the 2801Pro (2801 and 2801e should be similar) it is possible to setup the throttle curve, dual rate and expo for the 2406/A/B RX range. This is done by switching stickmode (COMPTB) to 2801, doing the setup, and then switching back to 2401 stickmode. The settings made will stay.
After going back into 2401 stickmode the bind should automaticly come back (if you left the rx connected to the battery). if not, just do a re-bind.
This video show how:
That is soooo coooool Rob!!!!!
I have 5 micro planes(delta,bi plan,Fox…) based on 4#3 RX and 5 heli with 5G6 or 4#3 RX and all I need is EXPO!!!!now I have it!!
Great!!
it fully work with my 2801E TX
thank a lot man
Jay
great Jay! im glad this helped you.
im just modding an x-twin to 2.4Ghz with 2609 rx (4G6) and the 2801 for differential thrust mixing. brushless, proportional actuator… so im into micro planes now too.
Hallo,
ich schaffe es einfach nicht, bei meinem Walkera 2801Pro Sender die Hot Key Funktion aufzurufen.
Kannst Du mir helfen?
Besten Dank im voraus!#
Robert R.
Hi,
ich habe gerade mal in die Anleitung geschaut – so wie dort beschrieben geht es nicht. Ich komme nicht in das Hot-Key Menü. Scheint nicht zu funktionieren.
Rob
Hi
I new here but i cant find what i am trying to find, i know you can help me
well i bought 4g6 with walkera 2602 tx
it came from hong kong and the setting are totally on the tx i dont know what to do
Kindly can you tell me
what to reverse and what to let normal
because when i tried to fly it, it went opposit direction, Mode 2 is ok
but its even unable to lift and if i move it right it goes left and vice versa
Please can you tell me step by step setting for the walkera 2602 tx bcoz i am between biggner and intermediate stage
I will be so much thankful
thanks in advance
Majid
Hi Majid,
i do not own a 2602, so i can only tell you my settings on the 2801.
they are ch 1, 4 and 6 reverse, others normal.
if you are not sure, just try different reverse settings. make sure that you DONT change the reverse settings while the heli is powered and bound to the transmitter, because you might reverse the throttle and you cause damage by an unwanted lift-off. First adjust the settings while the heli battery is unplugged, then bind again. Also you should fix the heli the ground by putting something heavy through the landinggear to make sure it is unable to lift off if you make some unwanted settings.
hope that helps.
Regards,
Rob
Thanks Rob
I will try all what you said, But anywhere you can find settings for wk2602 tx with walkera 4g6
please share it here
i tried on rc channels but i couldnt find and even no one wants to reply back
thanks so much for replying and giving me help
Majid
Here is a link to the Walkera 2602 manual pdf.
http://www.walkera.com/cn/upload/explain/W22602_expe.pdf
Rob
Thanks Rob
You are great !!!!!!!
Majid
Hallo!
Also man kann definitiv die WK-2802/2801 (WK-2602) zwar im 4CH-Mode betreiben aber die Einstellungen des 6CH-Modes funktionieren hier nicht !!!
Cu Andreas