PicooZ Pluto (Havoc) actuators controlled by servoboards and the Walkera 2406 Rx (2.4GHz). Centering magnets used. Second vid down is a little flight demo.
Component weights
marc on RC Groups showed us this FPV PicooZ. Now check this out, Prox Dynamics (i blogged about Prox Dynamic’s FPV heli here)!
Marc and his FPV Picooz
First step towards building a brushless direct drive 2.4Ghz gyro-ed PizooZ. The shaft of the HP03T 2.9 BL outrunner was replaced by a 50mm 1.5mm shaft that holds the picooZ main rotor. The picooZ rotor head was drilled to 1.5mm (stock is 1mm). The HP03T is normally used for the Walkera 4#3B brushless tail conversion. The motor is power by the flea converter.
Thrust at mid-stick is about 20g – about right, remains to be seen if the revomix works out.
I’m aiming for about 15g AUW for the 2Ch – if it works as planned this will be the platform for the acutator cyclics mod (see post here).
Amazingly quiet!
RC Groups User marc31 just presented the first brushless conversion of the PicooZ. The mod is based on the 2.4 GHz Walkera 4#3B 4-1. The cyclics are controlled by actuators.
